Contact Us

Tel:+86-577-86911198

Fax:+86-577-88955793

Mob:+8613868377523

E-mail: sales@vgshmn.com

Add: No.78, Yan'ao Industry Zone, Wenzhou, Zhejiang, China

Home > News > Content
Socket Easy To Connect With Other Circuits Nov 03, 2017

The socket has one or more circuit wiring can be inserted in the seat, through which can be plugged into a variety of wiring, easy to connect with other circuits. Through the connection and disconnect between the line and the copper piece, to reach and disconnect the part of the circuit eventually.

Connection method

1, first use Tape to find the FireWire;

2. Turn off the outlet power;

3, the FireWire access switch 2 holes in a mark, and then from another hole to a 2. The 5mm2 insulated wire is connected to the L hole in 3 holes in the socket below;

4, find out 0 line direct access socket 3 holes in the N hole to connect in prison;

5, find the ground direct access to the socket 3 holes in the e hole to connect the prison.

Note: 0, the ground can not be connected to the wrong (general face socket left 0 right fire on the ground, or plug in the power equipment, a trip will be tripped.

Select attention

1. Power sockets should be used by the state-related product quality Supervision departments inspected qualified products.

2. Residential power sockets should be used safe sockets, toilets and other humid places should be used to splash-resistant sockets;

3. The rated current of the power outlet shall be greater than 1.25 times times the rated current of the known equipment. The General single-phase power outlet rated current is 10A, the special power outlet is 16A, the special high-power household electrical appliances its distribution circuit and the connection power mode should according to the actual capacity choice;

4. In order to plug in convenient, the number of the combination of sockets is best for two, up to (including switches) not more than three;

5. The electrical appliances with electric shock hazard in the plugged power supply should use the socket with switch to disconnect the power supply.

6, in the more humid places, installation sockets should be installed at the same time waterproof box.

Installation Note

1. The installation height of the socket should be installed according to the design requirement when the design is provided. When the design is not clear, the general should conform to: the socket with a safety door is not less than 0.3M; the socket with no safety door is not lower than 1.8M; It is recommended that you buy as many sockets as possible with a safe door, as the prices are not very different.

2. In the bathroom or other damp place should use the seal good waterproof, the splash-proof socket. (Note: A socket with a safety door is a plastic bezel (safety door) that is added to the front of the jack Metal Reed on the basis of a general outlet. Three-hole socket, when the plug into the grounding pile head (slightly longer) first into the hole, the socket inside the mechanism action side open the other two holes, the two-hole sockets must be inserted at the same time socket pile head, safety door can be opened to prevent children mistakenly inserted metal into the safety accident. )

3. When the socket is installed, the panel should be upright and close to the wall surface. and the wiring (phase) should conform to: single-phase two-hole sockets, the right or upper hole of the socket is connected with the line (FireWire), the Zokong or the lower hole is connected to the 0 line, the three hole socket, the right hole of the socket is connected with the line (L, FireWire), the Zokong is 0 lines (N), the upper hole grounding Line (PE).